DR2025 Drum Counter Reset – HL2040 HL2030 HL2070

Replaced the DR2025 Drum on your Brother HL2040 HL2030 HL2070 and the light doesn’t  go out? That’s because you have to reset the drum counter when you replace the drum unit.

To reset the counter on your new drum unit please follow the procedure listed below.

  1. Turn printer on if it isn’t already.
  2. Open the front cover.
  3. Press and hold the “GO” button for about 4 seconds until all the LED’s light up.
  4. Release the Go button
  5. Close the front cover

Your drum counter should now be reset.

Note: This should get you printing again. If you have not replaced the drum your printing will drop in quality as the drum wears down. You’ll still need to replace the drum at some stage. REMEMBER to reset the counter when you replace the drum unit.

Easyink Support has written 83 articles

If you found this information useful, or have a question or suggestion, please comment below...

Your email address will not be published. Required fields are marked *

You may use these HTML tags and attributes: <a href="" title=""> <abbr title=""> <acronym title=""> <b> <blockquote cite=""> <cite> <code> <del datetime=""> <em> <i> <q cite=""> <s> <strike> <strong>