Brother HL2270DW HL2240D Toner Reset – TN2250 ~ TN2230

If your TN2230 – TN2250 toner counter on your HL-2130 HL-2240D HL-2250DN or HL-2270DW doesn’t reset when you install the cartridge, you may wish to try this procedure.

  1.  Open the front cover and leave open while  completing the following steps.
  2. Turn the printer off.
  3. Hold the ‘go’  button (or “start’ button) while turning the printer on. All panel lights should  be on.
  4. Release the ‘go’ button (or “start’ button).
  5. Press the ‘go’  button (or “start’ button) 2 times.
  6. Pause. All panel lights should be  on.
  7. Press the ‘go’ button (or “start’ button) 5 times.
    The toner light  should be off (the error light may be flashing).
    The paper light should be on or  flashing.
  8. Close the cover. The ready light should be the only light on.

Note: This procedure has been tested on the HL2130 HL2240D HL2250DN and HL2270DW printer but may work on other printers using the TN2250 toner.

Some users have reported having to turn the printer off and on after resetting the counter.

Easyink Support has written 79 articles

10 thoughts on “Brother HL2270DW HL2240D Toner Reset – TN2250 ~ TN2230

  1. Glen says:

    This fixed my problem. I’m not a “natural” at this, and I had tried for two days to get my printer (2 months old) working with its new compatible toner cartridge.
    What schmucks Brother are for setting it up like this. I am most unimpressed.
    Thanks for this advice.

    1. Easyink Support says:

      Hi Jim

      This one does work as I have used it myself many times. It will only work if the front cover/ toner door is open. You also have to perform the steps quickly as there seems to be a time out for the reset.

  2. Charlene says:

    Well, I got this darn error message off and on all day. My paper kept getting stuck inside while printing. Discovered that my power strip kept turning off (never had one go out before). Replaced the power strip with a new one. Error message came up again and I began resetting my printer AGAIN AND AGAIN. I opened the front cover, looked inside, no paper stuck. Opened the back door by the power plug, no paper stuck. Looked in the paper drawer to see if anything was stuck there… nothing. But the error persisted! Finally, I saw everyone was saying there was a problem with the toner… so I removed the toner and the cartridge felt stuck… a piece of paper was jammed inside where it couldn’t be seen. I pulled it out and… WA LA! No more error message. I must’ve reset my printer a half dozen times AT LEAST. Now it works. Hopefully this jamming problem doesn’t happen again. I’ve never had issues in 2 yrs since owning it.

  3. Steven says:

    This works to get my 2240DW printing, but it still says “toner low” even though the cartridge is new and it will shut down again saying “replace toner” within a day.

Cancel reply

Leave a Reply to Glen

Your email address will not be published. Required fields are marked *

You may use these HTML tags and attributes: <a href="" title=""> <abbr title=""> <acronym title=""> <b> <blockquote cite=""> <cite> <code> <del datetime=""> <em> <i> <q cite=""> <s> <strike> <strong>